1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
|
/* Copyright 2020 The Chromium OS Authors. All rights reserved.
* Use of this source code is governed by a BSD-style license that can be
* found in the LICENSE file.
*/
/* Configuration for Katsu */
#ifndef __CROS_EC_BOARD_H
#define __CROS_EC_BOARD_H
#define BQ27541_ADDR 0x55
#define VARIANT_KUKUI_BATTERY_BQ27541
#define VARIANT_KUKUI_POGO_KEYBOARD
#define VARIANT_KUKUI_CHARGER_MT6370
#define VARIANT_KUKUI_EC_STM32F098
#define VARIANT_KUKUI_TABLET_PWRBTN
#ifndef SECTION_IS_RW
#define VARIANT_KUKUI_NO_SENSORS
#endif /* SECTION_IS_RW */
#include "baseboard.h"
#define CONFIG_USB_MUX_IT5205
#define CONFIG_VOLUME_BUTTONS
#define CONFIG_USB_MUX_RUNTIME_CONFIG
/* Battery */
#define BATTERY_DESIRED_CHARGING_CURRENT 3500 /* mA */
#define CONFIG_CHARGER_MT6370_BACKLIGHT
/* Motion Sensors */
#ifdef SECTION_IS_RW
#define CONFIG_ACCELGYRO_ICM426XX
#define CONFIG_ACCELGYRO_ICM426XX_INT_EVENT \
TASK_EVENT_MOTION_SENSOR_INTERRUPT(LID_ACCEL)
/* Camera VSYNC */
#define CONFIG_SYNC
#define CONFIG_SYNC_COMMAND
#define CONFIG_SYNC_INT_EVENT TASK_EVENT_MOTION_SENSOR_INTERRUPT(VSYNC)
#endif /* SECTION_IS_RW */
/* I2C ports */
#define I2C_PORT_CHARGER 0
#define I2C_PORT_TCPC0 0
#define I2C_PORT_USB_MUX 0
#define I2C_PORT_BATTERY 1
#define I2C_PORT_VIRTUAL_BATTERY I2C_PORT_BATTERY
#define I2C_PORT_ACCEL 1
#define I2C_PORT_BC12 1
/* Route sbs host requests to virtual battery driver */
#define VIRTUAL_BATTERY_ADDR_FLAGS 0x0B
/* MKBP */
#define CONFIG_MKBP_INPUT_DEVICES
#define CONFIG_MKBP_EVENT
#define CONFIG_MKBP_EVENT_WAKEUP_MASK \
(BIT(EC_MKBP_EVENT_SENSOR_FIFO) | BIT(EC_MKBP_EVENT_HOST_EVENT))
#undef CONFIG_MKBP_HOST_EVENT_WAKEUP_MASK
#define CONFIG_MKBP_HOST_EVENT_WAKEUP_MASK \
(EC_HOST_EVENT_MASK(EC_HOST_EVENT_LID_OPEN) | \
EC_HOST_EVENT_MASK(EC_HOST_EVENT_POWER_BUTTON) | \
EC_HOST_EVENT_MASK(EC_HOST_EVENT_AC_CONNECTED) | \
EC_HOST_EVENT_MASK(EC_HOST_EVENT_AC_DISCONNECTED) | \
EC_HOST_EVENT_MASK(EC_HOST_EVENT_MODE_CHANGE))
#define PD_OPERATING_POWER_MW 15000
#ifndef __ASSEMBLER__
enum adc_channel {
/* Real ADC channels begin here */
ADC_BOARD_ID = 0,
ADC_EC_SKU_ID,
ADC_BATT_ID,
ADC_POGO_ADC_INT_L,
ADC_CH_COUNT
};
/* power signal definitions */
enum power_signal {
AP_IN_S3_L,
PMIC_PWR_GOOD,
/* Number of signals */
POWER_SIGNAL_COUNT,
};
/* Motion sensors */
enum sensor_id {
LID_ACCEL = 0,
LID_GYRO,
VSYNC,
SENSOR_COUNT,
};
enum charge_port {
CHARGE_PORT_USB_C,
};
#include "gpio_signal.h"
#include "registers.h"
#ifdef SECTION_IS_RO
/* Interrupt handler for emmc task */
void emmc_cmd_interrupt(enum gpio_signal signal);
#endif
void board_reset_pd_mcu(void);
int board_get_version(void);
void pogo_adc_interrupt(enum gpio_signal signal);
int board_discharge_on_ac(int enable);
/* Enable double tap detection */
#define CONFIG_GESTURE_DETECTION
#define CONFIG_GESTURE_SENSOR_DOUBLE_TAP
#define CONFIG_GESTURE_TAP_SENSOR 0
#define CONFIG_GESTURE_SENSOR_DOUBLE_TAP_FOR_HOST
#define CONFIG_GESTURE_SAMPLING_INTERVAL_MS 5
#define CONFIG_GESTURE_TAP_THRES_MG 100
#define CONFIG_GESTURE_TAP_MAX_INTERSTICE_T 500
#define CONFIG_GESTURE_DETECTION_MASK BIT(CONFIG_GESTURE_TAP_SENSOR)
#endif /* !__ASSEMBLER__ */
#endif /* __CROS_EC_BOARD_H */
|
