blob: 740d6b7c06332e10b3086007150aa6f94bbfb7f0 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
|
/* Copyright 2014 The Chromium OS Authors. All rights reserved.
* Use of this source code is governed by a BSD-style license that can be
* found in the LICENSE file.
*
* USB API definitions.
*
* This file includes definitions needed by common code that wants to control
* the state of the USB peripheral, but doesn't need to know about the specific
* implementation.
*/
#ifndef __CROS_EC_USB_API_H
#define __CROS_EC_USB_API_H
/*
* Initialize the USB peripheral, enabling its clock and configuring the DP/DN
* GPIOs correctly. This function is called via an init hook (unless the board
* defined CONFIG_USB_INHIBIT_INIT), but may need to be called again if
* usb_release is called. This function will call usb_connect by default
* unless CONFIG_USB_INHIBIT_CONNECT is defined.
*/
void usb_init(void);
/* Check if USB peripheral is enabled. */
int usb_is_enabled(void);
/*
* Enable the pullup on the DP line to signal that this device exists to the
* host and to start the enumeration process.
*/
void usb_connect(void);
/*
* Disable the pullup on the DP line. This causes the device to be disconnected
* from the host.
*/
void usb_disconnect(void);
/*
* Disconnect from the host by calling usb_disconnect and then turn off the USB
* peripheral, releasing its GPIOs and disabling its clock.
*/
void usb_release(void);
/*
* Returns true if USB device is currently suspended.
* Requires CONFIG_USB_SUSPEND to be defined.
*/
int usb_is_suspended(void);
/*
* Preserve in non-volatile memory the state of the USB hardware registers
* which cannot be simply re-initialized when powered up again.
*/
void usb_save_suspended_state(void);
/*
* Restore from non-volatile memory the state of the USB hardware registers
* which was lost by powering them down.
*/
void usb_restore_suspended_state(void);
/*
* Tell the host to wake up. Requires CONFIG_USB_REMOTE_WAKEUP to be defined,
* and a chip that implements the function.
*
* Returns immediately, suspend status can be checked using usb_is_suspended.
*/
void usb_wake(void);
/* Board-specific USB wake, for side-band wake, called by usb_wake above. */
void board_usb_wake(void);
#ifdef CONFIG_USB_SELECT_PHY
/* Select which PHY to use. */
void usb_select_phy(uint32_t phy);
/* Get the current PHY */
uint32_t usb_get_phy(void);
#endif
#endif /* __CROS_EC_USB_API_H */
|