diff options
Diffstat (limited to 'Documentation/devicetree')
4 files changed, 6 insertions, 7 deletions
diff --git a/Documentation/devicetree/bindings/net/fsl-enetc.txt b/Documentation/devicetree/bindings/net/fsl-enetc.txt index c812e25ae90f..25fc687419db 100644 --- a/Documentation/devicetree/bindings/net/fsl-enetc.txt +++ b/Documentation/devicetree/bindings/net/fsl-enetc.txt @@ -16,8 +16,8 @@ Required properties: In this case, the ENETC node should include a "mdio" sub-node that in turn should contain the "ethernet-phy" node describing the external phy. Below properties are required, their bindings -already defined in ethernet.txt or phy.txt, under -Documentation/devicetree/bindings/net/*. +already defined in Documentation/devicetree/bindings/net/ethernet.txt or +Documentation/devicetree/bindings/net/phy.txt. Required: @@ -51,8 +51,7 @@ Example: connection: In this case, the ENETC port node defines a fixed link connection, -as specified by "fixed-link.txt", under -Documentation/devicetree/bindings/net/*. +as specified by Documentation/devicetree/bindings/net/fixed-link.txt. Required: diff --git a/Documentation/devicetree/bindings/pci/amlogic,meson-pcie.txt b/Documentation/devicetree/bindings/pci/amlogic,meson-pcie.txt index 12b18f82d441..efa2c8b9b85a 100644 --- a/Documentation/devicetree/bindings/pci/amlogic,meson-pcie.txt +++ b/Documentation/devicetree/bindings/pci/amlogic,meson-pcie.txt @@ -3,7 +3,7 @@ Amlogic Meson AXG DWC PCIE SoC controller Amlogic Meson PCIe host controller is based on the Synopsys DesignWare PCI core. It shares common functions with the PCIe DesignWare core driver and inherits common properties defined in -Documentation/devicetree/bindings/pci/designware-pci.txt. +Documentation/devicetree/bindings/pci/designware-pcie.txt. Additional properties are described here: diff --git a/Documentation/devicetree/bindings/regulator/qcom,rpmh-regulator.txt b/Documentation/devicetree/bindings/regulator/qcom,rpmh-regulator.txt index 7ef2dbe48e8a..14d2eee96b3d 100644 --- a/Documentation/devicetree/bindings/regulator/qcom,rpmh-regulator.txt +++ b/Documentation/devicetree/bindings/regulator/qcom,rpmh-regulator.txt @@ -97,7 +97,7 @@ Second Level Nodes - Regulators sent for this regulator including those which are for a strictly lower power state. -Other properties defined in Documentation/devicetree/bindings/regulator.txt +Other properties defined in Documentation/devicetree/bindings/regulator/regulator.txt may also be used. regulator-initial-mode and regulator-allowed-modes may be specified for VRM regulators using mode values from include/dt-bindings/regulator/qcom,rpmh-regulator.h. regulator-allow-bypass diff --git a/Documentation/devicetree/booting-without-of.txt b/Documentation/devicetree/booting-without-of.txt index e86bd2f64117..60f8640f2b2f 100644 --- a/Documentation/devicetree/booting-without-of.txt +++ b/Documentation/devicetree/booting-without-of.txt @@ -277,7 +277,7 @@ it with special cases. the decompressor (the real mode entry point goes to the same 32bit entry point once it switched into protected mode). That entry point supports one calling convention which is documented in - Documentation/x86/boot.txt + Documentation/x86/boot.rst The physical pointer to the device-tree block (defined in chapter II) is passed via setup_data which requires at least boot protocol 2.09. The type filed is defined as |