diff options
Diffstat (limited to 'include/net/mac80211.h')
| -rw-r--r-- | include/net/mac80211.h | 150 |
1 files changed, 132 insertions, 18 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index d52914b75331..201bc68e0cff 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -301,17 +301,86 @@ enum ieee80211_bss_change { #define IEEE80211_BSS_ARP_ADDR_LIST_LEN 4 /** - * enum ieee80211_rssi_event - RSSI threshold event - * An indicator for when RSSI goes below/above a certain threshold. - * @RSSI_EVENT_HIGH: AP's rssi crossed the high threshold set by the driver. - * @RSSI_EVENT_LOW: AP's rssi crossed the low threshold set by the driver. + * enum ieee80211_event_type - event to be notified to the low level driver + * @RSSI_EVENT: AP's rssi crossed the a threshold set by the driver. + * @MLME_EVENT: event related to MLME */ -enum ieee80211_rssi_event { +enum ieee80211_event_type { + RSSI_EVENT, + MLME_EVENT, +}; + +/** + * enum ieee80211_rssi_event_data - relevant when event type is %RSSI_EVENT + * @RSSI_EVENT_HIGH: AP's rssi went below the threshold set by the driver. + * @RSSI_EVENT_LOW: AP's rssi went above the threshold set by the driver. + */ +enum ieee80211_rssi_event_data { RSSI_EVENT_HIGH, RSSI_EVENT_LOW, }; /** + * enum ieee80211_rssi_event - data attached to an %RSSI_EVENT + * @data: See &enum ieee80211_rssi_event_data + */ +struct ieee80211_rssi_event { + enum ieee80211_rssi_event_data data; +}; + +/** + * enum ieee80211_mlme_event_data - relevant when event type is %MLME_EVENT + * @AUTH_EVENT: the MLME operation is authentication + * @ASSOC_EVENT: the MLME operation is association + * @DEAUTH_RX_EVENT: deauth received.. + * @DEAUTH_TX_EVENT: deauth sent. + */ +enum ieee80211_mlme_event_data { + AUTH_EVENT, + ASSOC_EVENT, + DEAUTH_RX_EVENT, + DEAUTH_TX_EVENT, +}; + +/** + * enum ieee80211_mlme_event_status - relevant when event type is %MLME_EVENT + * @MLME_SUCCESS: the MLME operation completed successfully. + * @MLME_DENIED: the MLME operation was denied by the peer. + * @MLME_TIMEOUT: the MLME operation timed out. + */ +enum ieee80211_mlme_event_status { + MLME_SUCCESS, + MLME_DENIED, + MLME_TIMEOUT, +}; + +/** + * enum ieee80211_mlme_event - data attached to an %MLME_EVENT + * @data: See &enum ieee80211_mlme_event_data + * @status: See &enum ieee80211_mlme_event_status + * @reason: the reason code if applicable + */ +struct ieee80211_mlme_event { + enum ieee80211_mlme_event_data data; + enum ieee80211_mlme_event_status status; + u16 reason; +}; + +/** + * struct ieee80211_event - event to be sent to the driver + * @type The event itself. See &enum ieee80211_event_type. + * @rssi: relevant if &type is %RSSI_EVENT + * @mlme: relevant if &type is %AUTH_EVENT + */ +struct ieee80211_event { + enum ieee80211_event_type type; + union { + struct ieee80211_rssi_event rssi; + struct ieee80211_mlme_event mlme; + } u; +}; + +/** * struct ieee80211_bss_conf - holds the BSS's changing parameters * * This structure keeps information about a BSS (and an association @@ -337,12 +406,15 @@ enum ieee80211_rssi_event { * HW flag %IEEE80211_HW_TIMING_BEACON_ONLY is set, then this can * only come from a beacon, but might not become valid until after * association when a beacon is received (which is notified with the - * %BSS_CHANGED_DTIM flag.) + * %BSS_CHANGED_DTIM flag.). See also sync_dtim_count important notice. * @sync_device_ts: the device timestamp corresponding to the sync_tsf, * the driver/device can use this to calculate synchronisation - * (see @sync_tsf) + * (see @sync_tsf). See also sync_dtim_count important notice. * @sync_dtim_count: Only valid when %IEEE80211_HW_TIMING_BEACON_ONLY * is requested, see @sync_tsf/@sync_device_ts. + * IMPORTANT: These three sync_* parameters would possibly be out of sync + * by the time the driver will use them. The synchronized view is currently + * guaranteed only in certain callbacks. * @beacon_int: beacon interval * @assoc_capability: capabilities taken from assoc resp * @basic_rates: bitmap of basic rates, each bit stands for an @@ -1279,6 +1351,19 @@ static inline bool ieee80211_vif_is_mesh(struct ieee80211_vif *vif) struct ieee80211_vif *wdev_to_ieee80211_vif(struct wireless_dev *wdev); /** + * ieee80211_vif_to_wdev - return a wdev struct from a vif + * @vif: the vif to get the wdev for + * + * This can be used by mac80211 drivers with direct cfg80211 APIs + * (like the vendor commands) that needs to get the wdev for a vif. + * + * Note that this function may return %NULL if the given wdev isn't + * associated with a vif that the driver knows about (e.g. monitor + * or AP_VLAN interfaces.) + */ +struct wireless_dev *ieee80211_vif_to_wdev(struct ieee80211_vif *vif); + +/** * enum ieee80211_key_flags - key flags * * These flags are used for communication about keys between the driver @@ -1472,7 +1557,8 @@ struct ieee80211_sta_rates { * @supp_rates: Bitmap of supported rates (per band) * @ht_cap: HT capabilities of this STA; restricted to our own capabilities * @vht_cap: VHT capabilities of this STA; restricted to our own capabilities - * @wme: indicates whether the STA supports QoS/WME. + * @wme: indicates whether the STA supports QoS/WME (if local devices does, + * otherwise always false) * @drv_priv: data area for driver use, will always be aligned to * sizeof(void *), size is determined in hw information. * @uapsd_queues: bitmap of queues configured for uapsd. Only valid @@ -1488,6 +1574,7 @@ struct ieee80211_sta_rates { * @tdls: indicates whether the STA is a TDLS peer * @tdls_initiator: indicates the STA is an initiator of the TDLS link. Only * valid if the STA is a TDLS peer in the first place. + * @mfp: indicates whether the STA uses management frame protection or not. */ struct ieee80211_sta { u32 supp_rates[IEEE80211_NUM_BANDS]; @@ -1504,6 +1591,7 @@ struct ieee80211_sta { struct ieee80211_sta_rates __rcu *rates; bool tdls; bool tdls_initiator; + bool mfp; /* must be last */ u8 drv_priv[0] __aligned(sizeof(void *)); @@ -2844,8 +2932,9 @@ enum ieee80211_reconfig_type { * @set_bitrate_mask: Set a mask of rates to be used for rate control selection * when transmitting a frame. Currently only legacy rates are handled. * The callback can sleep. - * @rssi_callback: Notify driver when the average RSSI goes above/below - * thresholds that were registered previously. The callback can sleep. + * @event_callback: Notify driver about any event in mac80211. See + * &enum ieee80211_event_type for the different types. + * The callback can sleep. * * @release_buffered_frames: Release buffered frames according to the given * parameters. In the case where the driver buffers some frames for @@ -3141,9 +3230,9 @@ struct ieee80211_ops { bool (*tx_frames_pending)(struct ieee80211_hw *hw); int (*set_bitrate_mask)(struct ieee80211_hw *hw, struct ieee80211_vif *vif, const struct cfg80211_bitrate_mask *mask); - void (*rssi_callback)(struct ieee80211_hw *hw, - struct ieee80211_vif *vif, - enum ieee80211_rssi_event rssi_event); + void (*event_callback)(struct ieee80211_hw *hw, + struct ieee80211_vif *vif, + const struct ieee80211_event *event); void (*allow_buffered_frames)(struct ieee80211_hw *hw, struct ieee80211_sta *sta, @@ -4343,13 +4432,33 @@ void ieee80211_sched_scan_stopped(struct ieee80211_hw *hw); * haven't been re-added to the driver yet. * @IEEE80211_IFACE_ITER_RESUME_ALL: During resume, iterate over all * interfaces, even if they haven't been re-added to the driver yet. + * @IEEE80211_IFACE_ITER_ACTIVE: Iterate only active interfaces (netdev is up). */ enum ieee80211_interface_iteration_flags { IEEE80211_IFACE_ITER_NORMAL = 0, IEEE80211_IFACE_ITER_RESUME_ALL = BIT(0), + IEEE80211_IFACE_ITER_ACTIVE = BIT(1), }; /** + * ieee80211_iterate_interfaces - iterate interfaces + * + * This function iterates over the interfaces associated with a given + * hardware and calls the callback for them. This includes active as well as + * inactive interfaces. This function allows the iterator function to sleep. + * Will iterate over a new interface during add_interface(). + * + * @hw: the hardware struct of which the interfaces should be iterated over + * @iter_flags: iteration flags, see &enum ieee80211_interface_iteration_flags + * @iterator: the iterator function to call + * @data: first argument of the iterator function + */ +void ieee80211_iterate_interfaces(struct ieee80211_hw *hw, u32 iter_flags, + void (*iterator)(void *data, u8 *mac, + struct ieee80211_vif *vif), + void *data); + +/** * ieee80211_iterate_active_interfaces - iterate active interfaces * * This function iterates over the interfaces associated with a given @@ -4364,11 +4473,16 @@ enum ieee80211_interface_iteration_flags { * @iterator: the iterator function to call * @data: first argument of the iterator function */ -void ieee80211_iterate_active_interfaces(struct ieee80211_hw *hw, - u32 iter_flags, - void (*iterator)(void *data, u8 *mac, - struct ieee80211_vif *vif), - void *data); +static inline void +ieee80211_iterate_active_interfaces(struct ieee80211_hw *hw, u32 iter_flags, + void (*iterator)(void *data, u8 *mac, + struct ieee80211_vif *vif), + void *data) +{ + ieee80211_iterate_interfaces(hw, + iter_flags | IEEE80211_IFACE_ITER_ACTIVE, + iterator, data); +} /** * ieee80211_iterate_active_interfaces_atomic - iterate active interfaces |