diff options
Diffstat (limited to 'Documentation/devicetree/bindings/sound/samsung-i2s.txt')
-rw-r--r-- | Documentation/devicetree/bindings/sound/samsung-i2s.txt | 84 |
1 files changed, 0 insertions, 84 deletions
diff --git a/Documentation/devicetree/bindings/sound/samsung-i2s.txt b/Documentation/devicetree/bindings/sound/samsung-i2s.txt deleted file mode 100644 index a88cb00fa096..000000000000 --- a/Documentation/devicetree/bindings/sound/samsung-i2s.txt +++ /dev/null @@ -1,84 +0,0 @@ -* Samsung I2S controller - -Required SoC Specific Properties: - -- compatible : should be one of the following. - - samsung,s3c6410-i2s: for 8/16/24bit stereo I2S. - - samsung,s5pv210-i2s: for 8/16/24bit multichannel(5.1) I2S with - secondary fifo, s/w reset control and internal mux for root clk src. - - samsung,exynos5420-i2s: for 8/16/24bit multichannel(5.1) I2S for - playback, stereo channel capture, secondary fifo using internal - or external dma, s/w reset control, internal mux for root clk src - and 7.1 channel TDM support for playback. TDM (Time division multiplexing) - is to allow transfer of multiple channel audio data on single data line. - - samsung,exynos7-i2s: with all the available features of exynos5 i2s, - exynos7 I2S has 7.1 channel TDM support for capture, secondary fifo - with only external dma and more no.of root clk sampling frequencies. - - samsung,exynos7-i2s1: I2S1 on previous samsung platforms supports - stereo channels. exynos7 i2s1 upgraded to 5.1 multichannel with - slightly modified bit offsets. - -- reg: physical base address of the controller and length of memory mapped - region. -- dmas: list of DMA controller phandle and DMA request line ordered pairs. -- dma-names: identifier string for each DMA request line in the dmas property. - These strings correspond 1:1 with the ordered pairs in dmas. -- clocks: Handle to iis clock and RCLK source clk. -- clock-names: - i2s0 uses some base clocks from CMU and some are from audio subsystem internal - clock controller. The clock names for i2s0 should be "iis", "i2s_opclk0" and - "i2s_opclk1" as shown in the example below. - i2s1 and i2s2 uses clocks from CMU. The clock names for i2s1 and i2s2 should - be "iis" and "i2s_opclk0". - "iis" is the i2s bus clock and i2s_opclk0, i2s_opclk1 are sources of the root - clk. i2s0 has internal mux to select the source of root clk and i2s1 and i2s2 - doesn't have any such mux. -- #clock-cells: should be 1, this property must be present if the I2S device - is a clock provider in terms of the common clock bindings, described in - ../clock/clock-bindings.txt. -- clock-output-names (deprecated): from the common clock bindings, names of - the CDCLK I2S output clocks, suggested values are "i2s_cdclk0", "i2s_cdclk1", - "i2s_cdclk3" for the I2S0, I2S1, I2S2 devices respectively. - -There are following clocks available at the I2S device nodes: - CLK_I2S_CDCLK - the CDCLK (CODECLKO) gate clock, - CLK_I2S_RCLK_PSR - the RCLK prescaler divider clock (corresponding to the - IISPSR register), - CLK_I2S_RCLK_SRC - the RCLKSRC mux clock (corresponding to RCLKSRC bit in - IISMOD register). - -Refer to the SoC datasheet for availability of the above clocks. -The CLK_I2S_RCLK_PSR and CLK_I2S_RCLK_SRC clocks are usually only available -in the IIS Multi Audio Interface. - -Note: Old DTs may not have the #clock-cells property and then not use the I2S -node as a clock supplier. - -Optional SoC Specific Properties: - -- samsung,idma-addr: Internal DMA register base address of the audio - sub system(used in secondary sound source). -- pinctrl-0: Should specify pin control groups used for this controller. -- pinctrl-names: Should contain only one value - "default". -- #sound-dai-cells: should be 1. - - -Example: - -i2s0: i2s@3830000 { - compatible = "samsung,s5pv210-i2s"; - reg = <0x03830000 0x100>; - dmas = <&pdma0 10 - &pdma0 9 - &pdma0 8>; - dma-names = "tx", "rx", "tx-sec"; - clocks = <&clock_audss EXYNOS_I2S_BUS>, - <&clock_audss EXYNOS_I2S_BUS>, - <&clock_audss EXYNOS_SCLK_I2S>; - clock-names = "iis", "i2s_opclk0", "i2s_opclk1"; - #clock-cells = <1>; - samsung,idma-addr = <0x03000000>; - pinctrl-names = "default"; - pinctrl-0 = <&i2s0_bus>; - #sound-dai-cells = <1>; -}; |