1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
|
/* SPDX-License-Identifier: LGPL-2.1-or-later */
#pragma once
/***
Copyright © 2017 Intel Corporation. All rights reserved.
***/
#include "sd-radv.h"
#include "list.h"
#include "network-common.h"
#include "sparse-endian.h"
#include "time-util.h"
/* RFC 4861 section 6.2.1.
* MaxRtrAdvInterval
* The maximum time allowed between sending unsolicited multicast Router Advertisements from the
* interface, in seconds. MUST be no less than 4 seconds and no greater than 1800 seconds.
* Default: 600 seconds */
#define RADV_MIN_MAX_TIMEOUT_USEC (4 * USEC_PER_SEC)
#define RADV_MAX_MAX_TIMEOUT_USEC (1800 * USEC_PER_SEC)
#define RADV_DEFAULT_MAX_TIMEOUT_USEC (600 * USEC_PER_SEC)
/* RFC 4861 section 6.2.1.
* MinRtrAdvInterval
* The minimum time allowed between sending unsolicited multicast Router Advertisements from the
* interface, in seconds. MUST be no less than 3 seconds and no greater than .75 * MaxRtrAdvInterval.
* Default: 0.33 * MaxRtrAdvInterval If MaxRtrAdvInterval >= 9 seconds; otherwise, the Default is
* MaxRtrAdvInterval (Note, this should be a typo. We use 0.75 * MaxRtrAdvInterval). */
#define RADV_MIN_MIN_TIMEOUT_USEC (3 * USEC_PER_SEC)
/* RFC 4861 section 6.2.4.
* AdvDefaultLifetime
* The value to be placed in the Router Lifetime field of Router Advertisements sent from the interface,
* in seconds. MUST be either zero or between MaxRtrAdvInterval and 9000 seconds. A value of zero
* indicates that the router is not to be used as a default router. These limits may be overridden by
* specific documents that describe how IPv6 operates over different link layers. For instance, in a
* point-to-point link the peers may have enough information about the number and status of devices at
* the other end so that advertisements are needed less frequently.
* Default: 3 * MaxRtrAdvInterval */
#define RADV_MIN_ROUTER_LIFETIME_USEC RADV_MIN_MAX_TIMEOUT_USEC
#define RADV_MAX_ROUTER_LIFETIME_USEC (9000 * USEC_PER_SEC)
#define RADV_DEFAULT_ROUTER_LIFETIME_USEC (3 * RADV_DEFAULT_MAX_TIMEOUT_USEC)
/* draft-ietf-6man-slaac-renum-02 section 4.1.1.
* AdvPreferredLifetime: max(AdvDefaultLifetime, 3 * MaxRtrAdvInterval)
* AdvValidLifetime: 2 * AdvPreferredLifetime */
#define RADV_DEFAULT_PREFERRED_LIFETIME_USEC CONST_MAX(RADV_DEFAULT_ROUTER_LIFETIME_USEC, 3 * RADV_DEFAULT_MAX_TIMEOUT_USEC)
#define RADV_DEFAULT_VALID_LIFETIME_USEC (2 * RADV_DEFAULT_PREFERRED_LIFETIME_USEC)
/* RFC 4861 section 10.
* MAX_INITIAL_RTR_ADVERT_INTERVAL 16 seconds
* MAX_INITIAL_RTR_ADVERTISEMENTS 3 transmissions
* MAX_FINAL_RTR_ADVERTISEMENTS 3 transmissions
* MIN_DELAY_BETWEEN_RAS 3 seconds
* MAX_RA_DELAY_TIME .5 seconds */
#define RADV_MAX_INITIAL_RTR_ADVERT_INTERVAL_USEC (16 * USEC_PER_SEC)
#define RADV_MAX_INITIAL_RTR_ADVERTISEMENTS 3
#define RADV_MAX_FINAL_RTR_ADVERTISEMENTS 3
#define RADV_MIN_DELAY_BETWEEN_RAS 3
#define RADV_MAX_RA_DELAY_TIME_USEC (500 * USEC_PER_MSEC)
#define RADV_OPT_ROUTE_INFORMATION 24
#define RADV_OPT_RDNSS 25
#define RADV_OPT_DNSSL 31
enum RAdvState {
RADV_STATE_IDLE = 0,
RADV_STATE_ADVERTISING = 1,
};
typedef enum RAdvState RAdvState;
struct sd_radv_opt_dns {
uint8_t type;
uint8_t length;
uint16_t reserved;
be32_t lifetime;
} _packed_;
struct sd_radv {
unsigned n_ref;
RAdvState state;
int ifindex;
char *ifname;
sd_event *event;
int event_priority;
struct ether_addr mac_addr;
uint8_t hop_limit;
uint8_t flags;
uint32_t mtu;
usec_t lifetime_usec; /* timespan */
int fd;
unsigned ra_sent;
sd_event_source *recv_event_source;
sd_event_source *timeout_event_source;
unsigned n_prefixes;
LIST_HEAD(sd_radv_prefix, prefixes);
unsigned n_route_prefixes;
LIST_HEAD(sd_radv_route_prefix, route_prefixes);
size_t n_rdnss;
struct sd_radv_opt_dns *rdnss;
struct sd_radv_opt_dns *dnssl;
};
#define radv_prefix_opt__contents { \
uint8_t type; \
uint8_t length; \
uint8_t prefixlen; \
uint8_t flags; \
be32_t lifetime_valid; \
be32_t lifetime_preferred; \
uint32_t reserved; \
struct in6_addr in6_addr; \
}
struct radv_prefix_opt radv_prefix_opt__contents;
/* We need the opt substructure to be packed, because we use it in send(). But
* if we use _packed_, this means that the structure cannot be used directly in
* normal code in general, because the fields might not be properly aligned.
* But in this particular case, the structure is defined in a way that gives
* proper alignment, even without the explicit _packed_ attribute. To appease
* the compiler we use the "unpacked" structure, but we also verify that
* structure contains no holes, so offsets are the same when _packed_ is used.
*/
struct radv_prefix_opt__packed radv_prefix_opt__contents _packed_;
assert_cc(sizeof(struct radv_prefix_opt) == sizeof(struct radv_prefix_opt__packed));
struct sd_radv_prefix {
unsigned n_ref;
struct radv_prefix_opt opt;
LIST_FIELDS(struct sd_radv_prefix, prefix);
/* These are timespans, NOT points in time. */
usec_t lifetime_valid_usec;
usec_t lifetime_preferred_usec;
/* These are points in time specified with clock_boottime_or_monotonic(), NOT timespans. */
usec_t valid_until;
usec_t preferred_until;
};
#define radv_route_prefix_opt__contents { \
uint8_t type; \
uint8_t length; \
uint8_t prefixlen; \
uint8_t flags_reserved; \
be32_t lifetime; \
struct in6_addr in6_addr; \
}
struct radv_route_prefix_opt radv_route_prefix_opt__contents;
struct radv_route_prefix_opt__packed radv_route_prefix_opt__contents _packed_;
assert_cc(sizeof(struct radv_route_prefix_opt) == sizeof(struct radv_route_prefix_opt__packed));
struct sd_radv_route_prefix {
unsigned n_ref;
struct radv_route_prefix_opt opt;
LIST_FIELDS(struct sd_radv_route_prefix, prefix);
/* This is a timespan, NOT a point in time. */
usec_t lifetime_usec;
/* This is a point in time specified with clock_boottime_or_monotonic(), NOT a timespan. */
usec_t valid_until;
};
#define log_radv_errno(radv, error, fmt, ...) \
log_interface_prefix_full_errno( \
"RADV: ", \
sd_radv, radv, \
error, fmt, ##__VA_ARGS__)
#define log_radv(radv, fmt, ...) \
log_interface_prefix_full_errno_zerook( \
"RADV: ", \
sd_radv, radv, \
0, fmt, ##__VA_ARGS__)
|
