1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
|
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright 2018 NXP
*/
#include <common.h>
#include <linux/kernel.h>
#include <asm/arch/ddr.h>
#include <asm/arch/lpddr4_define.h>
int ddr_cfg_phy(struct dram_timing_info *dram_timing)
{
struct dram_cfg_param *dram_cfg;
struct dram_fsp_msg *fsp_msg;
unsigned int num;
int i = 0;
int j = 0;
int ret;
/* initialize PHY configuration */
dram_cfg = dram_timing->ddrphy_cfg;
num = dram_timing->ddrphy_cfg_num;
for (i = 0; i < num; i++) {
/* config phy reg */
dwc_ddrphy_apb_wr(dram_cfg->reg, dram_cfg->val);
dram_cfg++;
}
/* load the frequency setpoint message block config */
fsp_msg = dram_timing->fsp_msg;
for (i = 0; i < dram_timing->fsp_msg_num; i++) {
debug("DRAM PHY training for %dMTS\n", fsp_msg->drate);
/* set dram PHY input clocks to desired frequency */
ddrphy_init_set_dfi_clk(fsp_msg->drate);
/* load the dram training firmware image */
dwc_ddrphy_apb_wr(0xd0000, 0x0);
ddr_load_train_firmware(fsp_msg->fw_type);
/* load the frequency set point message block parameter */
dram_cfg = fsp_msg->fsp_cfg;
num = fsp_msg->fsp_cfg_num;
for (j = 0; j < num; j++) {
dwc_ddrphy_apb_wr(dram_cfg->reg, dram_cfg->val);
dram_cfg++;
}
/*
* -------------------- excute the firmware --------------------
* Running the firmware is a simply process to taking the
* PMU out of reset and stall, then the firwmare will be run
* 1. reset the PMU;
* 2. begin the excution;
* 3. wait for the training done;
* 4. read the message block result.
* -------------------------------------------------------------
*/
dwc_ddrphy_apb_wr(0xd0000, 0x1);
dwc_ddrphy_apb_wr(0xd0099, 0x9);
dwc_ddrphy_apb_wr(0xd0099, 0x1);
dwc_ddrphy_apb_wr(0xd0099, 0x0);
/* Wait for the training firmware to complete */
ret = wait_ddrphy_training_complete();
if (ret)
return ret;
/* Halt the microcontroller. */
dwc_ddrphy_apb_wr(0xd0099, 0x1);
/* Read the Message Block results */
dwc_ddrphy_apb_wr(0xd0000, 0x0);
ddrphy_init_read_msg_block(fsp_msg->fw_type);
dwc_ddrphy_apb_wr(0xd0000, 0x1);
fsp_msg++;
}
/* Load PHY Init Engine Image */
dram_cfg = dram_timing->ddrphy_pie;
num = dram_timing->ddrphy_pie_num;
for (i = 0; i < num; i++) {
dwc_ddrphy_apb_wr(dram_cfg->reg, dram_cfg->val);
dram_cfg++;
}
/* save the ddr PHY trained CSR in memory for low power use */
ddrphy_trained_csr_save(ddrphy_trained_csr, ddrphy_trained_csr_num);
return 0;
}
|
