1 files changed, 0 insertions, 56 deletions
diff --git a/baseboard/volteer/power.c b/baseboard/volteer/power.c
deleted file mode 100644
index fa20cfa93f..0000000000
--- a/baseboard/volteer/power.c
+++ /dev/null
@@ -1,56 +0,0 @@
-/* Copyright 2021 The Chromium OS Authors. All rights reserved.
- * Use of this source code is governed by a BSD-style license that can be
- * found in the LICENSE file.
- */
-
-#include "gpio.h"
-#include "hooks.h"
-#include "power/icelake.h"
-
-/*
- * PWROK signal configuration, see the PWROK Generation Flow Diagram (Figure
- * 235) in the Tiger Lake Platform Design Guide for the list of potential
- * signals.
- *
- * Volteer uses this power sequence:
- *	GPIO_EN_PPVAR_VCCIN - Turns on the VCCIN rail. Also used as a delay to
- *		the VCCST_PWRGD input to the AP so this signal must be delayed
- *		5 ms to meet the tCPU00 timing requirement.
- *	GPIO_EC_PCH_SYS_PWROK - Asserts the SYS_PWROK input to the AP. Delayed
- *		a total of 50 ms after ALL_SYS_PWRGD input is asserted. See
- *		b/144478941 for full discussion.
- *
- * Volteer does not provide direct EC control for the VCCST_PWRGD and PCH_PWROK
- * signals. If your board adds these signals to the EC, copy this array
- * to your board.c file and modify as needed.
- */
-const struct intel_x86_pwrok_signal pwrok_signal_assert_list[] = {
-	{
-		.gpio = GPIO_EN_PPVAR_VCCIN,
-		.delay_ms = 5,
-	},
-	{
-		.gpio = GPIO_EC_PCH_SYS_PWROK,
-		.delay_ms = 50 - 5,
-	},
-};
-const int pwrok_signal_assert_count = ARRAY_SIZE(pwrok_signal_assert_list);
-
-const struct intel_x86_pwrok_signal pwrok_signal_deassert_list[] = {
-	/* No delays needed during S0 exit */
-	{
-		.gpio = GPIO_EC_PCH_SYS_PWROK,
-	},
-	/* Turn off VCCIN last */
-	{
-		.gpio = GPIO_EN_PPVAR_VCCIN,
-	},
-};
-const int pwrok_signal_deassert_count = ARRAY_SIZE(pwrok_signal_deassert_list);
-
-static void baseboard_init(void)
-{
-	/* Enable monitoring of the PROCHOT input to the EC */
-	gpio_enable_interrupt(GPIO_EC_PROCHOT_IN_L);
-}
-DECLARE_HOOK(HOOK_INIT, baseboard_init, HOOK_PRIO_DEFAULT);