diff options
Diffstat (limited to 'config/gdm.conf-custom')
-rw-r--r-- | config/gdm.conf-custom | 66 |
1 files changed, 0 insertions, 66 deletions
diff --git a/config/gdm.conf-custom b/config/gdm.conf-custom deleted file mode 100644 index 16df4c3e..00000000 --- a/config/gdm.conf-custom +++ /dev/null @@ -1,66 +0,0 @@ -# GDM Configuration Customization file. -# -# This file is the appropriate place for specifying your customizations to the -# GDM configuration. If you run gdmsetup, it will automatically edit this -# file for you and will cause the daemon and any running GDM GUI programs to -# automatically update with the new configuration. Not all configuration -# options are supported by gdmsetup, so to modify some values it may be -# necessary to modify this file directly by hand. -# -# Older versions of GDM used the "gdm.conf" file for configuration. If your -# system has an old gdm.conf file on the system, it will be used instead of -# this file - so changes made to this file will not take effect. Consider -# migrating your configuration to this file and removing the gdm.conf file. -# -# To hand-edit this file, simply add or modify the key=value combination in -# the appropriate section in the template below. Refer to the comments in the -# /usr/share/gdm/defaults.conf file for information about each option. Also -# refer to the reference documentation. -# -# If you hand edit a GDM configuration file, you should run the following -# command to get the GDM daemon to notice the change. Any running GDM GUI -# programs will also be notified to update with the new configuration. -# -# gdmflexiserver --command="UPDATE_CONFIG <configuration key>" -# -# e.g, the "Enable" key in the "[debug]" section would be "debug/Enable". -# -# You can also run gdm-restart or gdm-safe-restart to cause GDM to restart and -# re-read the new configuration settings. You can also restart GDM by sending -# a HUP or USR1 signal to the daemon. HUP behaves like gdm-restart and causes -# any user session started by GDM to exit immediately while USR1 behaves like -# gdm-safe-restart and will wait until all users log out before restarting GDM. -# -# For full reference documentation see the gnome help browser under -# GNOME|System category. You can also find the docs in HTML form on -# http://www.gnome.org/projects/gdm/ -# -# NOTE: Lines that begin with "#" are considered comments. -# -# Have fun! - -[daemon] - -[security] - -[xdmcp] - -[gui] - -[greeter] - -[chooser] - -[debug] - -# Note that to disable servers defined in the defaults.conf file (such as -# 0=Standard, you must put a line in this file that says 0=inactive, as -# described in the Configuration section of the GDM documentation. -# -[servers] - -# Also note, that if you redefine a [server-foo] section, then GDM will -# use the definition in this file, not the defaults.conf file. It is -# currently not possible to disable a [server-foo] section defined -# in the defaults.conf file. -# |